Supports the Picture Control system which allows image parameters to be selected and adjusted on a computer, and custom curves (tone compensation data) to be created and saved back to the camera. Most settings of Nikon digital SLRs, that are connected via USB cables, such as exposure mode, shutter speed, and aperture can be controlled remotely from a computer. In Tripod mode, remote selection of the desired autofocus point is possible. Nikon Camera Control Pro also supports the workflows of Nikon’s exclusive photofinishing software Capture NX (optional) and browser and viewer software ViewNX. I am facing one important problem - Ill explain : 1. LiveView support enables simultaneous adjustment of focus point and/or shutter release, and confirmation of the image on a computer screen. Hello All : I have JUST purchased the Nikon Software 'Camera Control Pro'. Supports LiveView modes (Hand-held and Tripod) where the camera sensor is used to provide a real-time preview through the objective lens. Both tethered or wireless configurations are supported, and a wide variety of camera settings can be managed using the intuitive on-screen interface. Images on a camera buffer can be confirmed or deleted with thumbnail or preview display on a computer prior to transfer. Camera Control Pro 2 facilitates remote capture of images from Nikon digital SLR cameras to the computer hard disk. Operation by wired and wireless LAN when using a wireless transmitter.ĭirect transfer of images from a camera to a computer and workflow management of all procedures from shooting to saving images.Įnhanced Viewer function enables thumbnail display of images stored on a computer. Camera Control Pro 2 compatibility and a software development kit. Remote control of most Nikon digital SLR settings, including exposure mode, shutter speed and aperture, from a computer. It also supports workflows from Nikon's exclusive photofinishing and browser software. When you take a photo, it goes straight to your computer. In addition to the new Nikon Z9, Z6 II & Z7 II firmware updates, Nikon also released the new Picture Control Utility 2 Version 2.4. It lets you control the D5000 from your Mac or PC over the USB connection. Advanced camera features are supported including LiveView, Picture Control system and the Viewer, which collectively enable the preview and selection of images prior to transfer to a computer. Camera Control Pro is a software by Nikon for some of its digital camera devices. Connection between the computer and camera may be via USB cable, or through wired or wireless LAN using a wireless transmitter. Camera Control Pro 2 software enables remote control of the settings on most Nikon cameras.
0 Comments
Leave a Reply. |